ETNA AV361RVS Mode D'emploi page 40

INSTALLATION
Mounting
EN 10
Drilling the Support surface and Fitting the Hood
• The hood support surface must be 135 mm above the bottom
surface of the wall units.
• Drill the support with a ø 4,5 mm drill bit, using the drilling template
provided.
• Cut a hole ø150 mm in size on the support surface, using the
drilling template provided.
• Fix using the 4 screws '12a' (4,2 x 44,4) provided.
264
15
Closing element
• The space between the edge of the hood and the rear wall can be
closed by applying the element '20' provided, using the screws
supplied for this purpose.