Before Using For The First Time; Charging The Battery - Rowenta AIR FORCE Manuel De L'utilisateur

DESCRIPTION
1. Ergonomic handle
2. On off button
2.a "Off" position
2.b "Floor" position
2.c "Carpet" position
3. Booster lighted button (LED)
4. Light charging indicator
5. Handle
6. Main body
7. Locking screw
8. Air flow grid
9. Dust compartment
9.a Dust container
9.b Dust separator
9.c Filter foam
9.d Cover

BEFORE USING FOR THE FIRST TIME

1 • Mounting the appliance
(See additional notice
supplied)
Unpack your device and get rid of all the
labels. Keep your warranty card and read the
instructions for use carefully before using
your appliance for the first time.
• Remove the screw from the handle and
leave the nut in its housing.
• Attach the handle by carefully inserting it
into the upper part of the main body (fig.1)
• Insert the blocking screw (7) into the handle
and tighten it with a screwdriver (fig.2).
• Attach the Delta vacuum head (11) by
clipping it on to the lower part of the main
body (fig. 3).
Note: to remove the Delta vacuum head,
press the eject button on the back (fig. 4) and
remove the vacuum head from the main body.
2 • Charging the battery
IMPORTANT Use only the original charger
supplied with the appliance. Never charge
below 0°C and above 35°C.
* Depending on model
10. Hose connector
11. Delta suction head with integrated
elecrobrush
11.a Electrobrush
11.b Flexible
11.c Small wheels
12. Wheels
13. Charger
- 18V: ref. RS-RH5025
14. Batteries
- 18V: ref. RS-RH5026
Before using your vacuum cleaner for the first
time, the battery must be charged for 6 hours.
When you are charging, the switch must be on
Stop (2.a)
• Place the vacuum cleaner near a power
outlet.
• Plug the charger into the mains and connect
it behind the handle (fig.5).
The indicator light will turn off when the bat-
tery is fully charged (~ 6H).
For optimal charging, you must leave the
charger on until the indicator light goes off.
NOTE : If the battery is not fully discharged,
it is natural that the charging time should be
short. If when charging, the LED only comes
on for a few seconds, this means that battery
is already charged.
The appliance can remain permanently on
charge without any risk. The charger might
heat up slightly, which is a perfectly normal
phenomenon. However, it is best to unplug
the charger in case of prolonged absence
(holidays, etc.).
11
EN