AVer DL30 Manuel D'utilisation page 40

System
The system information of camera is displayed in this page, including Model Name, IP Address, Serial
Number, MAC Address, and Firmware Version.
 Upgrade firmware: follows below steps to upgrade the firmware.
1. Download the newest firmware from:
Global: https://www.aver.com/download-center
USA: https://www.averusa.com/education/support
Europe: https://www.avereurope.com/download-center
2. Connect to the camera through the browser.
3. Select System > Upgrade firmware > Choose File.
4. Select the firmware and select the "Upgrade" button.
5. It takes about 5 minutes to finish update. After update, log in the web page again.
 Factory Default: clears all values and resets the camera back to factory default values.
 Login: the default login name and password are admin/admin. To change the login name and
password, enter the new login name and password and select the "Change" button.
 Language: changes the Web UI language.
 Save to Profile: saves up to 3 different settings including preset settings values, tracking mode,
and tracking setting values of camera.
[Note] The settings of profiles will be cleared after factory reset.
 Load Profile: loads up to 3 different settings of camera. After selecting Load Profile, camera will
go back to Home position.
 Sleep Timer: sets the duration of sleep timer. When there is no UVC and RTSP connection and
timer is up, camera will enter sleep mode.
 Camera Selector: selects a camera to operate.
31