Techno Line WS 8119 Guide D'utilisation page 9

Initial operation
 Open the base station battery compartment cover
 Insert 2 x AA batteries with correct polarity ("+" and "–" marks). Close the battery compartment cover.
 When you insert the batteries, all icons on the LCD will light up for 3 seconds, and you will hear a beep tone, then indoor temperature will appear.
 The base station will start to make a connection to the outdoor sensor. This operation takes about 3 minutes and will display by a flashing reception
RF antenna symbol in the "OUTDOOR" display area on the receiver.
 Open the outdoor sensor battery compartment cover and insert 2 x AA batteries with correct polarity ("+" and "–" marks). Close the battery
compartment cover.
 After the station has created a connection to the outdoor sensor, it will enter the DCF77 time reception mode 3 minutes later.
Part B – Back side
B1: "MEM" button
B2: "zZ" (SNOOZE) button
B3: "DOWN / WAVE / ALARM" button
B4: "UP / CH" button
B5: "SET" button
B6: Battery compartment cover
B7: Stand
B8: Wall mounting hole
Part C – Outdoor sensor
C1: Transmission LED
C2: Battery compartment cover
C3: Wall mounting hole
C4: "Reset" button
EN2