Operation; General; Maintenance; Daily Cleaning - Hatco Glo-Rite HL Série Manuel D'installation Et D'utilisation

English

General

Use the following information to operate a Display Light.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
CAUTION
Standard and approved manufacturing oils may smoke up
to 30 minutes during initial startup. This is a temporary
condition. Operate unit without food product until smoke
dissipates.
Startup
1. Move the Power I/O (on/off) switch to the I (on) position.
The display lights will illuminate.
General
Display Lights are designed for maximum durability and
performance with minimum maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Turn OFF power at fused disconnect switch/circuit
breaker and allow unit to cool before performing any
cleaning, adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not clean unit when it is energized or hot.
• Do not steam clean or use excessive water on unit.
• This unit is not "jet-proof" construction. Do not use
jet-clean spray to clean this unit.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
This unit has no "user-serviceable" parts. If service is required
on this unit, contact an Authorized Hatco Service Agent or
contact the Hatco Service Department at 800-558-0607 or
414-671-6350.
Form No. HLM-0519
Shutdown
1. Move the I/O (on/off) switch to the O (off) position.
2. Perform the "Daily Cleaning" procedure in the
MAINTENANCE section of this manual.

Daily Cleaning

To preserve the finish of the unit as well as maintain
performance, it is recommended that the unit be cleaned daily.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
1. Turn off the unit and allow it to cool completely.
2. Wipe down all metal surfaces using a
cloth
. Stubborn stains may be removed with a non-
abrasive cleaner. Hard to reach areas should be cleaned
with a small brush and mild soap.

Replacing a Display Light Bulb

Use the following procedure to replace a light bulb. To
order replacement incandescent light bulbs, use Hatco P/N
02.30.265.00 for 120 V bulbs.
Use only light bulbs that meet or exceed National
Sanitation Foundation (NSF) standards and are specifically
designed for food holding areas. Breakage of light bulbs
not specially-coated could result in personal injury and/or
food contamination.
1. Turn off the unit, disconnect from the power circuit, and
allow the unit to cool.
2. Bulbs have a threaded base. Unscrew the light bulb
from the unit and replace it with a new specially coated
incandescent bulb.
NOTE: Optional halogen bulbs are available. Order Hatco P/N
02.30.081.00 for 120 V bulbs.
7

OPERATION

Power I/O
(on/off) Switch
Controls

MAINTENANCE

NOTICE
soft, clean, damp
WARNING