Operation; General; Maintenance; Daily Cleaning - Hatco NLL Série Manuel D'installation Et D'utilisation

OPERATION

General

Use the following information to operate a NLL Series Narrow
Display Light.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION SECTION before operating this equipment.
Startup
1. Move the Power On/Off switch to the "On" position. The
LED light tube will illuminate.
Shutdown
1. Move the Power On/Off switch to the "Off" position.
2. Perform the "Daily Cleaning" procedure in the
MAINTENANCE section of this manual.
General
NLL Series Narrow Display Lights are designed for maximum
durability and performance with minimum maintenance.
WARNING
ELECTRIC SHOCK HAZARD:
• Turn OFF power switch, unplug power cord, and
allow unit to cool before performing any cleaning,
adjustments, or maintenance.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Do not steam clean or use excessive water on the unit.
• This unit is not "jet-proof" construction. Do not use
jet-clean spray to clean this unit.
• Do not clean unit when it is energized or hot.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts will void all warranties and may
subject operators of the equipment to hazardous
electrical voltage, resulting in electrical shock or burn.
Genuine Hatco Replacement Parts are specified to
operate safely in the environments in which they are
used. Some aftermarket or generic replacement parts
do not have the characteristics that will allow them to
operate safely in Hatco equipment.
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350.
NLL Series Power On/Off Switch

Daily Cleaning

To preserve the finish of the unit as well as maintain
performance, it is recommended that the unit be cleaned daily.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
1. Turn off the unit, unplug the power cord, and allow the unit
to cool.
2. Wipe down all metal surfaces using a non-abrasive,
damp cloth. Stubborn stains may be removed with a non-
abrasive cleaner. Hard to reach areas should be cleaned
with a small brush and mild soap.
3. Wipe dry the entire unit using a non-abrasive, dry cloth.
6
English
Power On/Off
Switch
NOTICE
Form No. NLLM-1216