Installation; General; Suspension Mounting; Adjustable Angle Bracket Mounting - Hatco Glo-Rite HL Série Manuel D'installation Et D'utilisation

INSTALLATION

General

Use the information in this section to prepare for installation of
a Glo-Rite Display Light.
®
WARNING
ELECTRIC SHOCK HAZARD:
• Unit must be installed by a qualified electrician.
Installation must conform to all local electrical codes.
Installation by unqualified personnel will void unit
warranty and may lead to electric shock or burn, as
well as damage to unit and/or its surroundings.
• Consult a licensed electrical contractor for proper
electrical installation conforming to local electrical
codes and the National Electrical Code (N.E.C.).
FIRE HAZARD: Locate unit the correct distance from
combustible walls and materials. If safe distances are not
maintained, discoloration or combustion could occur.
1. Remove the unit from the carton.
NOTE: To prevent delay in obtaining warranty coverage,
complete online warranty registration. See the
IMPORTANT OWNER INFORMATION section for
details.
2. Remove tape and protective packaging from all surfaces
of the unit.
3. Install/mount the unit in an appropriate location.
a. For suspension installation, refer to "Suspension
Mounting" in this section.
b. For permanent unit installation, refer to "Adjustable
Angle Bracket Mounting" in this section.

Suspension Mounting

Suspension mounting attaches a display light to an overhead
surface determined by a qualified installer.
WARNING
For installation with chains, make sure the chains have
sufficient strength and are securely fastened to both the
unit and the mounting location. Poorly installed chains
may cause the unit to loosen and fall. Do not place
anything on top of units installed with chains.
1. Prepare the overhead mounting system for suspension
mounting. Make sure the system is secure and is set up
so the unit will be suspended at a level, safe, and proper
distance from walls, counter, and food.
2. Suspend the unit using the two suspension holes on both
of the suspension brackets.
3. Carefully lift the unit and attach each end of the unit to the
overhead mounting system. Make sure the unit is level.
Suspension Mounting
Suspension
Bracket

Adjustable Angle Bracket Mounting

Mounting a display light with adjustable angle brackets
permanently attaches the unit to the underside of a shelf. Units
can be mounted to a flat shelf or a shelf with rolled/flanged
edges.
Use the following procedure to install adjustable angle brackets
on each end of the unit.
1. Position the unit on a flat surface on its side with the Power
I/O (on/off) switch facing up.
2. Remove the two top screws on the end of the unit.
3. Align the adjustable angle bracket with the mounting holes.
4. Secure the angle bracket with the previously removed
screws.
5. Fasten the angle brackets to the underside of the shelf
using appropriate fasteners (not supplied by Hatco).
Adjustable Angle Bracket Installation

Electrical Information

Hatco provides a 1/2" (12 mm) trade size knockout opposite the
Power I/O (on/off) switch, 6" (152 mm) long pigtail wire leads,
and a separate grounding terminal in the wiring compartment.
For correct installation, provide supply wires rated for at least
194°F (90°C) from a properly sized fused disconnect or circuit
breaker conforming to local electrical codes. Use UL recognized
wire nuts rated for at least 194°F (90°C) and properly sized for
connection.
Consult a local licensed electrical contractor if you have any
questions on proper installation. Refer to the Electrical Rating
Chart for specific information.
6
English
Adjustable Angle
Bracket
Form No. HLM-0519