Publicité
Step 8
Step
Fasten two METAL BRACKETS (4G) to the BOTTOM (E). Use two
å
BLACK 9/16" LARGE HEAD SCREWS (1S).
NOTE: Be sure the edges of the METAL BRACKETS are even with the
å
edge of the BOTTOM.
Fasten the BOTTOM MOLDING (S) to the BOTTOM (E). Tighten four
å
HIDDEN CAMS.
Fasten the PLINTHS (R2) to the ENDS (A2 and B2) and BOTTOM (E).
å
Tighten two TWIST-LOCK® FASTENERS and use two BLACK 9/16"
LARGE HEAD SCREWS (1S).
R2
4G
Caution
Risk of damage or
injury. HIDDEN CAMS
must be completely
tightened. HIDDEN
CAMS that are not
completely tightened
may loosen, and parts
may separate. To
completely tighten:
www.sauder.com/services
Curved edge
B2
S
E
Start
Arrow
BLACK 9/16" LARGE HEAD SCREW
(4 used for the METAL BRACKETS)
R2
Tighten
Maximum
210 degrees
Minimum
190 degrees
411830
1S
A2
Curved edge
Arrow
Page 13
Publicité
