Publicité
Step
Step 10
Carefully turn your unit over onto its front edges. Unfold the BACK (F)
å
and lay it over your unit.
Make equal margins along three edges of the BACK (F). The BACK will
å
overhang the BOTTOM (E) slightly. Push on opposite corners of your
unit if needed to make it "square".
Fasten the BACK (F) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the UPRIGHT (C2).
NOTE: Perforations have been provided for access through the BACK.
å
Carefully cut out the holes needed.
Push the FOOT (3E) into the hole in the BOTTOM (E).
å
Fasten the TIE PLATES (3G) to the BASE (H) and PLINTHS (R2). Use
å
four BLACK 9/16" LARGE HEAD SCREWS (1S).
Th BACK will overhang
the BOTTOM slightly.
R2
H
3G
www.sauder.com/services
F
3E
E
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
These holes must line up
over the UPRIGHT (C2).
Cut-out (used for mirror)
R2
411830
1N
NAIL
(60 used in this step)
BLACK 9/16" LARGE HEAD SCREW
(4 used for the TIE PLATES)
1S
Page 15
Publicité
