Hotpoint Ariston HDAI Serie Instructions De Montage Et D'utilisation page 27

Expansion wall plugs are provided to secure the hood
to most types of walls/ceilings. However, a qualified
technician must verify suitability of the materials in
accordance with the
wall/ceiling must be strong enough to take the weight
of the hood. Do not tile, grout or silicone this appliance
to the wall. Surface mounting only.
The hood is supplied in two versions: model for
installation to the wall and model for installation to the
ceiling.
The hood can look different to that illustrated in the
drawings in this booklet. The instructions for use,
maintenance and installation, however, remain the
same.
Installation ceiling model (Island)
1. Adjust the extension of the support structure of the
hood. The final height of the hood depends on this
adjustment.
Note: In some cases the upper section of the trellis
is fixed to the lower section with 1 or more screws.
Check and remove them temporarily to allow the
adjustment of the support structure.
2. Fix the two sections with a total of 16 screws (4 per
corner).
Apply 1 or 2 brackets as reinforcement for
extensions greater than the minimum (on the basis
of what is envisaged as equipment).
Note: 1 bracket can already be fixed to the trellis
temporarily with 2 screws during transport. Move it
into the desired position or complete fixing it with 6
additional screws, as follows:
a. Slightly stretch the brackets to be fixed in order
to be able to apply them outside the structure.
b. Position the reinforcement bracket immediately
above the fixing point of the two sections of the
structure and fix with a total of 8 screws (2 per
corner).
Fix the second reinforcement bracket, if supplied, in
a position midway between the first reinforcement
bracket and the upper side of the trellis and fix with
8 screws (2 per corner).
Note: check that there is no obstacle to an easy
fixing of the discharge tube (aspiration version) or
the deflector (filtering version) in positioning the
reinforcement bracket(s).
3. Hook the hood to the trellis and make sure that it is
perfectly hooked up. Screw the 16 screws up (4 per
corner) tightly to hook the hood to the trellis.
4. Apply the perforation diagram of the cooking top to
the ceiling vertically (the centre of the diagram must
correspond to the centre of the cooking top and the
sides must be parallel to the sides of the cooking
top – the side of the diagram with the word FRONT
corresponds to the control panel side). Prepare the
electrical connection.
5. Make holes as indicated (6 holes for 6 wall dowels –
4 dowels for hooking), and screw 4 screws into the
external holes, leaving a space of about 1 cm
type of wall/ceiling. The
between the head of the screws and the ceiling.
6. Hook the trellis to the ceiling with 4 screws, see
operation 4).
7. Screw the 4 screws up tightly.
8. Introduce and screw another 2 screws tightly into
the holes for fixing the safety elements remaining
free.
9. Introduce a discharge tube inside the trellis and
connect to the connecting ring of the motor space
(discharge tube and bands not supplied). The
discharge tube must be long enough to reach the
exterior (aspiration version) or the deflector (filtering
version).
10. Only for filtering version: mount deflector F onto the
trellis and fix it with 4 screws to the apposite
bracket and finally connect the discharge tube to
the connection ring placed on the deflector.
11. Connect the electricity to the domestic power.
Power must be supplied only after the installation
has been completed.
EN
27