Troubleshooting - GreenWorks 12A BLOWER Manuel Du Propriétaire

TROUBLESHOOTING

PROBLEM
Unit will not blow
or vac.
Unit will not start. 1. Unit is unplugged
POSSIBLE CAUSE
1. Bag full
2. Blocked tube
3. Blocked impeller
4. Dirty bag
5. Torn bag
6. Bag unzipped
7. Unit unplugged
2. Defective power switch
3. Vac tubes are not
correctly installed
4. House circuit may have
tripped
SOLUTION
1. Empty the bag
2. Clear the blockage
3. Clear the blockage
4. Clean the bag
5. Replace the bag
6. Zip up the bag
7. Plug into an outlet or an extension cord
1. Check cord to make sure it is plugged into
an electrical outlet.
2. Call toll free helpline: 1-888-909-6757.
3. Check vac tubes to ensure that they are
allowing the switch to be engaged when
correctly installed.
4. Check wall circuit breaker panel and reset
if necessary.
23