Kohler K-8761 Guide D'installation page 5

Valve Body
Inlet
Supply
Tube
Ferrule
Coupling Nut
Ferrule
Supply Stop
Valve Body
Inlet
5. Install the Supplies
NOTE: If the sink is not installed, install it at this time. Be sure to
follow all instructions packed with the sink.
Slide the coupling nuts and ferrules onto the supply tubes.
Carefully insert the supply tubes into the valve body inlets and
shut-off valve outlets (if used).
Position the round end of the supply tube squarely to the valve
body inlet and supply stop.
Tighten all coupling nuts.
6. Installation Checkout
Ensure that both faucet handles are turned up to the closed
position.
Turn on the hot and cold water supplies. Check for leaks.
Remove the aerator by turning it counterclockwise.
Turn on the hot and cold faucet handles for one minute to flush
debris from the faucet.
Close the hot and cold faucet handles.
Reattach the aerator by turning it clockwise until hand tight.
Kohler Co.
Aerator
5 1015079-2-G