Beem Thermo2Go Mode D'emploi page 22

EN
The device must always be disconnected from the mains when
•
it is left unattended and before assembling, disassembling, fi lling
or emptying the water tank or cleaning it.
In the interest of your own safety, check the device, the mains
•
cable and the mains plug for damage every time before use. Use
the device only if it is in working order.
Do not make any modifi cations to the device. Do not replace
•
the mains cable yourself. If the device, the mains cable or the
mains plug of the device is damaged, they must be replaced by
the manufacturer, customer service department or authorised
retailers in order to avoid any hazards.
It is essential to follow the instructions in the "Cleaning and Care"
•
chapter.
DANGER – Danger of Electric Shock from Water
• Use the device only in closed rooms.
• Do not use the device in rooms with high humidity.
• Should the device fall into water, switch off the power supply immediately. Do not attempt
to pull it out of the water while it is still connected to the mains power!
• Never touch the device, mains cable or mains plug with wet hands when these
components are connected to the mains power.
• Make sure that the steam which emerges is not aimed directly at electrical devices and
equipment containing electrical components.
WARNING – Danger of Electric Shock from Damage and
Inappropriate Use
• Only connect the device to a socket with safety contacts that is properly installed and
matches the technical data of the device. The socket must also be readily accessible
after connection so that the connection to the mains can quickly be isolated.
• Do not use the device in conjunction with extension cables.
• Lay the mains cable in such a way that it does not become squashed or bent and
does not come into contact with hot surfaces (also applies to the hot surfaces of the
device!).
03510_DE-EN-FR-NL_A5_V1.indb 20 03510_DE-EN-FR-NL_A5_V1.indb 20
20
19.10.2017 09:52:23 19.10.2017 09:52:23