Price Pfister TX8 Serie Manuel D'installation page 3

6
HOT
6D
6F
6A
6 IRON PIPE SUPPLY CONNECTIONS
Valve Body Inlets (6B) and Outlets (6C) are designed to accommodate 1 / 2 -14 NPT pipe.
Connect hot (6D) and cold (6E) water inlets to Valve Body (6A). Pipe Unions (6F) or
Couplings (6G) may be required (not included).
WARNING: For Iron Pipe Connections or threaded fittings, use thread sealant
or PTFE Plumber's tape according to manufacturer's instructions.
CAUTION: If using iron pipes, it is not recommended to reduce outlet pipe
diameter.
7
7C
HOT
7E
7F
7G
7 COPPER SUPPLY CONNECTIONS
Valve Body inlets (7A) and outlets (7B) are designed to accommodate a 1 / 2 " copper pipe.
Connect hot (7C) and cold (7D) water inlets to Valve Body (7E) and solder the joints.
WARNING: Remove Plaster Guard (7F), Backup Plate (7G) and Cartridge
Assembly (7H) prior to soldering any inlet or outlet connections. Failure to do so can
result in water damage.
For valves with integral stops, open valve stem prior to soldering see step 13.
6B
6C
COLD
6B
6C
6E
6G
7B
7A
7A
7D
7B
COLD
7H
ENGLISH
8
8D
48"
8" Min.
8 TUB & SHOWER OUTLET CONNECTIONS
Connect Shower (8A) and Tub (8B) Outlet Pipes to Valve Body (8C). Connect Pipe
Elbows (8D) (not included) to ends of both pipes. We recommend using drop elbows
(8D) (not included). Securely fasten to framing or other solid support. The height for
outlet pipes is measured from the center of pipe elbow to center of the valve body, as
shown.
WARNING: For Iron Pipe Connections or threaded fittings, use thread sealant
or PTFE Plumber's tape according to manufacturer's instructions.
WARNING:
valve and tub spout (No PEX)! Do not reduce the inner pipe
diameter!
9
9E
30" Min.
9 SHOWER ONLY OUTLET CONNECTIONS
Connect Shower Outlet Pipe (9A) to Valve Body (9B). Plug Bottom Outlet (9C) with
Pipe Cap or Plug (9D). Connect Pipe Elbow (9E) (not included) to end of the pipe. For
copper pipe outlets, we recommend using drop elbows (9E) (not included). Securely
fasten to framing or other solid support. The height for the outlet pipe is measured from
center of pipe elbow to center of valve body, as shown.
WARNING: For Iron Pipe Connections or threaded fittings, use thread sealant
or PTFE Plumber's tape according to manufacturer's instructions.
3
8A
8B
8D
Use only 1 / 2 " Iron or Copper Pipe between
9A
9B
9C
9D
8C