Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
1
ITEM(S) NEEDED
#10 x 1
a. Place the motor in the stowed position.
b. Unthread the Aluminum Rod (Item #4) from the
Stabilizer Bracket (Item #8) by removing the Top
Bumper (Item #10) and unscrewing the bracket.
Also remove the Bottom Bumper (Item #2). Keep
the Jam Nut (Item #6) in place.
2
ITEM(S) NEEDED
#12 x 2
c. Determine the desired orientation of the
Stabilizer Kit to attach it to the bottom of the
Bowguard/Steering Module.
NOTE:
or right side of the Bowguard/Steering
Module.
For the Fortrex, put the 5/16" Cap Screws
d.
(Item #14) through the Stabilizer Bracket and
the mounting holes on the Bowguard. Secure the
5/16" Cap Screws with the 5/16-18 Nylock Nut
(Item #12). The Nylock Nuts fit into a hex pocket
on the inside of the Bowguard behind the spring.
Secure with a 1/4" Allen Wrench. Tighten to
10 ft lbs.
NOTE:
#16) are not used when installing on the
Fortrex .
For the Ultrex, place a Lock Washer (Item #16)
e.
on the two 5/16" Cap Screws (Item #14).
Use the 5/16" Cap Screw to secure the
Stabilizer Bracket to the Steering Module using
a 1/4" Allen Wrench. Tighten to 10 ft lbs.
©2016 Johnson Outdoors Marine Electronics, Inc.
#8 x 1
#14 x 2
#16 x 2
The kit can be installed on the left
The two Lock Washers (Item
#4 x 1
#6 x 1
Top Bumper
Jam Nut
Stabilizer
Bracket
Fortrex
Bowguard
Cap Screw
Ultrex
Steering Module
Lock Washer and
Cap Screw
NOTE:
The two 5/16-18 Nylock Nuts (Item #12) are
not used when installing on the Ultrex.
#2 x 1
Bottom Bumper
Aluminum Rod
Nylock Nut
Stabilizer
Bracket
Stabilizer
Bracket
minnkotamotors.com | 2
Publicité
