Uline DOWNTOWN 52 po Mode D'emploi page 3

3. Using two people, place laminate panels within
frame and slide vertical bars over laminate panels.
Tighten bottom locks using Allen wrench.
(See Figure 3)
NOTE: Ensure bolt heads are facing the same
direction when inserting the horizontal and
vertical bars through remainder of assembly.
Figure 3
Vertical Bar
4. Starting from the top of posts, insert horizontal bar
between posts and slide it onto bottom row of
panels. Tighten locks using Allen wrench.
(See Figure 4)
Figure 4
Lock
PAGE 3 OF 15
STARTER DIVIDER ASSEMBLY CONTINUED
Laminate
Panel
Horizontal
Bar
5. Using two people, place acrylic panels within frame
and slide vertical bar over acrylic panels. Tighten
bottom lock using Allen wrench. (See Figure 5)
NOTE: Acrylic panels are covered with a
protective film. Peel off film before inserting
panels into frame.
Figure 5
Vertical Bar
6. Insert horizontal bar between posts and slide onto
top row of panels. Tighten locks using Allen wrench.
(See Figure 6)
Figure 6
Acrylic
Panel
1122 IH-9157