Cycle Start; Start Of A Cycle And Setting Of Delayed Start; Fast Advancement Function - Pixsys ATR 902 Manuel D'installation

8

Cycle start

8.1 Start of a cycle and setting of delayed start

Red display visualizes stop .
Press
Red display visualizes the cycle
1
CYCLE
selection.
Cycle starts. Buzzer sounds briefly.
Green display shows the process
2 while red display shows the
START
STOP
setpoint introduced on parameter
14 ui.d.2
If delayed start is active (see parameter 15 de.st. ) proceed as follows:
Press
Red display visualizes WAit Green
3 display shows (flashing)the
START
STOP
programmed waiting time.
Increases or decreases the initial
4
waiting time (hour:minutes).
Waiting starts.
5 When the programmed time
START
STOP
expires, cycle will start.

8.2 Fast advancement function

During functioning or after a restart it can be useful to move onwards or backwards
the cycle in progress, to reach chosen setpoint value.
Press
Forwards or backwards (each
1 beep of internal buzzer means
START
STOP
one minute).
14 - ATR902 - User manual
Display
Display
Display
Press CYCLE to scroll the cycles
( cy.02 for cycle no. 2 - cy. 1 5 for
cycle no. 15) until visualize the
chosen cycle.
NB: only cycles already
programmed can start.
Press or
time.
To end the cycle and stop the
controller before the normal
conclusion, press
Do
Do
to modify the
Do
for a 1".
START
STOP