Beko BKS 5316 T Mode D'emploi page 10

5 Cleaning and maintenance
A
WARNING: Cyclonic separator
should not be immersed in water.
NEVER USE detergent or boiled
C
water to wash the filters. It is
recommended to clean the filters
after each time you empty the dust
chamber.
4. Replace the dust chamber as described.
5.2.1 Cleaning the front motor
filter
C
This filter is located under the dust
chamber compartment.
1. Lift the tab to release the front motor filter. Lift
the filter cover to reach the filter. Pull the tab
towards yourself to remove the filter. (Figure
6/5)
Figure 6/5
2. Each filter can be beaten up against a bucket's
side to clean it from dirt and dust.
3. Front motor filters can be rinsed with lukewarm
water (max. 40 degrees). Let it dry for 24 hours
before installing.
4. After drying, attach the front motor filters and
cartridge back to the vacuum cleaner. Place the
cover of front motor filter back before operating
the vacuum cleaner.
10 / EN
5.2.2 Cleaning HEPA outlet filter
C
Hepa outlet filter is located on the
rear wheel of the vacuum cleaner.
1. Pull the tab towards yourself to remove the
filter. (Figure 6/6)
Figure 6/6
2. The filter can be beaten up against a bucket's
side to clean it from dirt and dust. (Figure 6/7)
Figure 6/7
3. Rear motor filter can be rinsed with lukewarm
water (max. 40 degrees). Let it dry for 24 hours
before replacing.
C
Never use detergent or boiled water
to wash the filters. Wash Hepa filter
once in 9-12 months.
4. After drying, replace the rear motor filter to the
vacuum cleaner. Replace the cover of rear motor
filter before operating the vacuum cleaner.
5.3 Storage
• If you do not intend to use the appliance for a
long time, store it carefully.
• Pull the appliance's plug out.
• Keep the appliance out of the reach of children.
Vacuum cleaner / User manual