Scope Of The Guarantee - Atlantic FLAT Mode D'emploi

•
When the water has a TH > 20°f, it is recommended that this be treated. When a softener is used, the
water hardness must remain above 15°f.
•
In case of prolonged absence, especially in winter, drain your appliance following the procedure
above.

SCOPE OF THE GUARANTEE

The water heater must be installed, used and maintained according to best practice and conform to the stan-
dards in force in the country in which it is installed and to the instructions contained in this document. In the
European Union this appliance is covered by the statutory guarantee accorded to consumers in accordance
with directive 1999/44/CE. This guarantee comes into force when the appliance is delivered to the consumer.
In addition to the legal guarantee, certain items are covered by an extra guarantee relating only to the free
exchange of the tank and of components accepted as defective. It does not include the cost of replacement or
carriage. Refer to the table below. This commercial guarantee does not affect your statutory rights. It applies
within the country where the product was acquired, provided it is also installed in the same country. The
dealer must be informed of any damage before the product is exchanged under guarantee and the appliance
will remain available for inspection by experts from the insurance company and the manufacturer.
Statutory guarantee
Extra commercial guarantee
on enamel tank and heating
element
Exclusions: Wear parts: magnesium anodes. Equipment which cannot be assessed (access difficult for repair,
maintenance or assessment). Equipment exposed to abnormal environmental conditions: frost, bad wea-
ther, water which is abnormally aggressive or outside drinking standards, electrical supply with large spikes.
Equipment installed without observing current standards in the country of installation: the absence or
incorrect fitting of safety devices, abnormal corrosion due to incorrect water fitments (iron/copper contact),
incorrect earthing, inadequate cable thickness, non-observance of the connection drawings shown in these
instructions. Equipment not maintained in accordance with these instructions. Repairs or replacement
of parts or components in the equipment not carried out or authorised by the company responsible for the
guarantee. Changing a component does not extend the life of the guarantee.
The products illustrated in these instructions may be modified at any time to reflect changes in manufacture
and current norms.
To claim under guarantee, contact your installer or dealer. If necessary, contact:
SPAIN and PORTUGAL: Pol.Industrial Cami Ral, Calle Molinot 59-62 – 08860 – Castelldefels (Barcelona)
Tél : 902 45 45 66 /
ITALIA : 848 800 929 (al solo costo di uno chiamata a tariffa urbana) / POLSKA : ul. Plochocińska 115 , 03-044
Warszawa tel (0800)-548-098 / OTHER COUNTRIES: +33 23 87 13 846
who will inform you of what you should do. The guarantee applies only to examine products which are
accepted as faulty by the company underwriting the guarantee. It is essential that products should be retai-
ned for inspection by them.
Type / Reference:
Serial number:
Name and address of
customer:
2 years
+3 years
STAMP DEALER
12