R&G FP0140BK Instructions De Montage page 2


Socket set to include 2x 10mm & 22mm sockets and wrenches.
FITTING INSTRUCTIONS

Remove the axle bolt from the left hand side fork leg using a 22mm socket.

Replace this bolt with the bolt supplied in the R&G kit and tighten to the recommended torque
setting.

Fit one nut and washer on spindle-bar (SB103) (the end with shorter turned down end), engage the
nut so the plastic insert of nut is fully engaged.

Feed spindle-bar with nut and washer through either crash protector (B0442 M6) and through the
metal spacer (S0662), as shown in the above picture.

Place this assembly through the front wheel spindle from the right hand side, ensuring the longer
turned down end locates through the center of the R&G bolt fitted to the left side fork leg. Locate
the boss on the metal spacer inside the end of the wheel spindle on the right side fork leg.

Place the remaining metal spacer (S0661) and crash protector over the exposed end of the spindle
bar on the left hand side. The metal spacer should locate over the bolt head.

Fit washer and nut from kit onto thread and tighten until both nuts are engaged in nylon and equal
amounts protrude from either side (please ensure the logo is located at the top of the crash
protector). Do not overtighten – the nyloc nuts will hold it tight.
TOOLS REQUIRED