Panasonic EY7411 Instructions D'utilisation page 10

to be driven can be changed within
the range of the screw count val-
ues.
3. To prevent changes in the set values
due to operational errors.
● Turn the HOLD switch
to ON.
■ While setting, if no operations are
conducted for 60 or more seconds or
when the battery is removed
● Operation for the set value be­
comes invalid.
Please reset the operational values.
■ When batteries are changed while in
use
● When batteries are changed, the
count value is saved. Therefore,
the drill can be used continuously.
 Battery Low Warning Lamp
<Battery low warning lamp>
Off
(normal
operation)
Excessive (complete) discharging of
Li-ion batteries shortens their service
life dramatically. The driver includes a
battery protection feature designed to
prevent excessive discharging of the
battery pack.
● The battery protection feature acti-
vates immediately before the bat-
tery loses its charge, causing the
battery low warning lamp to flash.
● If you notice the battery low warn-
ing lamp flashing, charge the bat-
tery pack immediately.
 Clutch Lock Cover
The clutch lock cover allows you to
lock the clutch at the selected setting.
Attaching the cover
1. Select the appropriate clutch set-
ting for the application.
EY7411(UL).indb 10
ON
Flashing
(No charge)
Battery
protection
feature active
- 10 -
. Attach the clutch lock cover.
● Align the triangle mark on the
cover with the graduation selec-
tion mark on the drill and attach.
Triangle mark Graduation selection
Removing the cover
1. Grip the clutch lock cover with your
fingers on the  mark and the bot-
tom of the cover, then push in and
twist to remove.
● It will be difficult to remove the
clutch lock cover from the drill if
you push on the side of the cover
while pulling it off.
 Using the LED Light
Use the LED light on jobs in dark
locations such as attics to illuminate
your workspace.
CAUTION
● The LED light is intended for use as
a supplemental light source. Do not
use it as a flashlight.
Doing so may result in accident or
injury.
● Do not look at the light or shine it
directly into your eyes.
Continuous exposure to the LED
light may damage your eyes.
1. Press to toggle the light on
and off.
● To use the light immediately after
attaching the battery pack or after
the drill has not been used for 5
minutes or more, operate the drill
briefly.
mark
2007/01/15 13:39:23