NAX 2000S Mode D'emploi page 40


The fuel tank should only be filled outdoors; do not smoke while refueling.

Gasoline should be topped up before starting the internal combustion engine.

Do not unscrew the fuel tank cap or add fuel while the internal combustion engine is running or when the engine is hot.

Do not overfill the fuel tank! Due to the thermal expansion of the fuel, do not fill the tank above the lower edge
of the filler neck.

The device must not be stored with the fuel tank filled indoors. The resulting gasoline vapors may come into contact with open
flames and ignite. If the fuel tank needs to be emptied, it should be done outdoors. Before starting the machine, make sure that
there is no spilled fuel on or near the machine. If necessary, wipe off the fuel.
Attention! Gasoline vapors are flammable. Before starting the mower, make sure that the working machine is not less than 3m
from fuel tanks.
OPERATION
BRAKE LEVER
Pull the brake lever 2 (Rys.(Fig.) 1) before starting the engine to the handle 1 (Rys.(Fig.) 1) as shown in Rys.(Fig.) 7.
By releasing the brake lever, the engine and cutting knife stop.
ENGINE STARTING
Warning! When the engine is running, the cutting blades rotate.
1. Check the oil level (Rys.(Fig.) 5B).
2. Fill the fuel tank with clean, unleaded gasoline (Rys.(Fig.) 4). Make sure the spark plug wire is connected to the spark plug
(Rys.(Fig.) 6).
3. Stand behind the mower. Hold the brake lever 2 (Rys.(Fig.) 1) with one hand in the working position as shown in Rys.(Fig.) 7.
4. With your other hand, grasp the starter cord handle 5 (Rys.(Fig.) 1) as shown in Rys.(Fig.) 9.
5. Lightly pulling the cord towards you, remove the starter slack, and when you feel resistance, pull the cord hard and vigorously
and let it slowly go back to its place.
6. Do not release the line handle until the line is pulled through the starter return system.
7. If the engine does not start after 5-6 strokes, follow the directions in the "Inspection and Troubleshooting" chapter.
WORKING WITH A DRIVE
To start the drive, pull it to the handle 1 (Rys.(Fig.) 1) drive lever 3 (Rys.(Fig.) 1) as shown in the Fig 8.
You can turn off the drive at any time by releasing the drive lever and operate the device like a mower without a drive.
MOWING HEIGHT SETTING
Attention! Before changing the cutting height, stop the engine and disconnect the spark plug cable.
To set the desired cutting height, change the position of the adjustment lever 24 (Rys.(Fig.) 10) located on the housing of the mower.
You can choose from 6 different cutting heights in the range of 25 - 75 mm.
INSTALLING THE GRASS BASKET
1. Raise the mower basket cover 23 (Rys.(Fig.) 2).
2. Insert the basket 7 (Rys.(Fig.) 1) attaching the hooks at the inlet to the basket on a rod designed for this purpose at the mower
outlet cover (Rys.(Fig.) 11), then lower the cover.
3. Make sure the hooks are attached correctly.
Warning! Often check the technical condition of the grass basket. If any parts are worn or damaged, they must be replaced
with new parts that are available at authorized service centers.
EMPTYING THE GRASS BASKET
Warning! Stop the engine before emptying and removing the basket.
Basket full indicato (Rys.(Fig.) 2) allows you to quickly assess the level of basket filling. If the indicator plate is raised while the
40 EN