NAX 2000S Mode D'emploi page 35

that may affect the operation of the device. If damage is found, the equipment must be repaired before use. Many accidents are
caused by improper repair and / or maintenance of the equipment.
 Before using the device, replace all defective, worn and damaged parts. Replace with new warning signs on the device if they
become illegible or damaged.
 Warning decals and spare parts can be ordered from NAX service and authorized dealers.
 An internal combustion tool, equipment, working tools etc. should be used in accordance with these instructions, taking into
account the conditions and the type of work to be performed. Using the device in a manner not intended for it may be dangerous.
OPERATION AND EXPLOITATION OF TOOLS EQUIPPED WITH A BATTERY
 Before inserting batteries into the tool, make sure that its on / off switch is in the "off" position. Inserting the batteries into
the device when the on / off switch is in the "on" position can cause serious injury.
 Use only the charger recommended by the manufacturer. Using a charger to charge other types of batteries may cause a fire.
 Never use batteries other than those recommended by the manufacturer. Use of other batteries may result in serious injury or fire.
 When the device is not in use, remove the battery. The battery should be kept away from metal objects such as paper clips,
coins, nails, screws, etc., which may short-circuit the battery terminals. Shorting the battery terminals together may cause burns
or a fire.
 Under extreme conditions, liquid may escape from the battery. You must avoid contact with it. If it accidentally it comes into
contact with liquid - rinse immediately with water. If liquid gets in your eyes, contact your doctor immediately. Liquids leaking from
the battery may cause irritation or burns.
 It is forbidden to use chargers and power supplies outside the rooms and in rooms with high humidity such as bathrooms
or basements.
CAUTION! Chargers and power supplies for battery devices are intended for indoor use in a dry environment. Danger
of electric shock and / or damage to the device.
REPAIR
 Before carrying out any adjustment, part replacement or storage, the spark plug wire must be removed. Such preventive safety
measures reduce the risk of accidental starting.
 Repair should be performed by a qualified person using only original spare parts. This will ensure further safe operation
of the device. It is recommended to have any service performed by an authorized NAX service center.
CAUTION! Danger of suffocation when children play with the packaging. The packaging, especially the foil bag, should
be stored out of the reach of children.
DETAILED SAFETY PROVISIONS FOR MOWERS
WARNING
 Beware of sharp knife edges. The blades rotate even after the engine has been turned off.
 You can only use the chain saw in good technical condition, perform the necessary actions if necessary or contact the service
center. It is recommended to use the services of an authorized NAX service.
 Before starting, check if:
 the device is assembled according to the operation manual;
 the cutting tool and the whole cutting unit (three-armed knife or head with a cutting line, fastening elements, construction of the cutting
unit) are in good technical condition; regularly check their attachment, damage and wear (depressions, cracks);
 safety devices (e.g. ejector cover, housing, steering handle, engine brake lever) are in good technical condition and work properly;
 the grass catcher is undamaged and correctly mounted, you cannot use a damaged grass basket.
 The mower must not be switched on unless the blade is correctly mounted. Danger of dangerous vibrations!
 Cutting tools should be sharp and clean. Properly keeping sharp edges of cutting tools reduces the likelihood of jamming
and simplifies handling.
 Before adjustment, cleaning, maintenance, switch off the device and remove the high voltage cable from the spark plug.
EN 35