Megasat Royal Line III 32 Mode D'emploi page 49

7. The Main Menu
Note:
As new Channels are available, but these are not located in your TV list, proceed as
follows:
1. Find out the frequency of the new channel (e. g. on „www.satindex.de").
2. Go to the main menu Channel -> Edit Satellite.
3. Select the satellite (e.g. Astra 19.2E) and confirm with OK.
4. Now open the transponder list.
5. Press the YELLOW button to add a transponder.
6. Enter the appropriate data (eg: 12.188 H 27.500)
7. Press the MENU button to save the new transponder.
8. Search manually for new channels.
9. See point 7.1.2 Manual search (satellite)
Unicable settings
If you are using the TV with a Unicable system, you can enter the corresponding data
here.
Motor
Choose between Off, DiSEqC 1.2 or 1.3 (USALS)
Band
Choose between KU and C band.
Note: Usually you have to make no changes in the antenna settings. It is recom-
mended that only experienced users change settings.
7.1.6 Signal informations
In this menu you can see various informa-
tion about the respective transponder or
channel. Signal quality and level can be
read here.
ENGLISH
15