Publicité
Les langues disponibles
Les langues disponibles
FLEXLINE ELECTRONIC PIN LOCK — INSTRUCTIONS FOR USE
Delete User From Specific Memory Slot (03 – 20)
The Supervisor Code memory location is called Slot 01 and the first User Code is called Slot 02.
•
The additional user codes reside in memory slots 03-20.
•
To delete a user code from a specific memory slot (03 -20), refer "RegulatoR Programming Mode" to enter programming mode.
NOTE: There is a 10 second programming time limit between each step. If RegulatoR times out or an error is made, programming will end
and you will need to enter programming mode again.
1.
Place RegulatoR into programming mode (See "RegulatoR Programming Mode").
2.
Press "401" and then press ENTER.
3.
Type memory slot to be vacated followed by ENTER (for memory slots 03 - 09, you must type leading "0" – e.g. "07" for slot 7).
4.
Retype memory slot to be vacated followed by ENTER.
5.
If successful, the yellow indicator light will illuminate.
Continue programming or press 9 and then ENTER to exit programming.
6
www.metro.com
L01-655
REV 01/20
Publicité
