Metro FLEXLINE ELECTRONIC PIN LOCK Mode D'emploi page 2

FLEXLINE ELECTRONIC PIN LOCK — INSTRUCTIONS FOR USE
CompX RegulatoR
®
The RegulatoR is used for locking cart drawers. It can mount to the cart top. Powered by 6-AA batteries (included), RegulatoR operates
using a 4 to 8 digit code. Operation is simple: type a valid code and press ENTER. Then just turn the lever to the locked or unlocked
position.
RegulatoR Lock offers:
• Programmable user and supervisor codes,
• Programmable modes of operation,
• Programmable reset features,
• RegulatoR is intended for interior use only,
Operating Temperature: 50°F – 120°F (10°C – 48°C).
•
Each lock contains 2 green stickers that are needed for resetting RegulatoR. In the event RegulatoR needs to be reset, one green sticker
is placed on the back of the device. The remaining green sticker should be saved in a safe and secure location for future reference.
(See "Reset Instructions" on page #4.)
Care and Cleaning
To clean the RegulatoR surface, apply non-acid based cleaner to a clean cotton cloth; do not spray cleaner directly on the RegulatoR.
Wipe down keypad and its respective housing surfaces of excess cleaner.
Powering Up and Battery Installation
CompX RegulatoR is shipped with six AA batteries. The yellow light on keypad of lock will indicate need for replacement. The Batteries
® ®
can be replaced by removing the top two drawers and the retainer bracket. Refer the steps below for battery replacement.
NOTE: Mixing batteries of different chemistries could damage the RegulatoR resulting in lock failure.
Battery Replacement:
1
Remove The Battery Housing Mounted On
Back Panel.
4
Press CLEAR "5" times
USER GUIDE
®
2
5
Insert New
Batteries
2
www.metro.com
3
Remove Battery Cover.
6
Reinstall Battery Cover And Reattach
Bracket
L01-655
REV 01/20