Publicité
Les langues disponibles
Les langues disponibles
Add User Without Specifying Memory Slot
The Supervisor Code memory location is called Slot 01 and the first User Code is called Slot 02.
•
Any additional user codes reside in memory slots 03-20.
•
To add a user code without specifying a memory slot (03 -20), refer to "RegulatoR Programming Mode" to enter programming
mode.
User codes must be 4 to 8 digits in length and must be different from all existing codes (including Slot 01 Supervisor & Slot 02 User
codes).
NOTE: There is a 10 second programming time limit between each step. If RegulatoR times out or an error is made, programming will
end and you will need to enter programming mode again.
1.
Place RegulatoR into programming mode (See "RegulatoR Programming Mode").
2.
Press "410" and then press ENTER.
3.
Type the new user code and press ENTER.
4.
Retype the new user code and press ENTER.
5.
If successful, the yellow indicator light will illuminate.
Continue programming or press 9 and then ENTER to exit programming.
Add User to Specific Memory Slot (03 – 20)
The Supervisor Code memory location is called Slot 01 and the first User Code is called Slot 02.
•
Any additional user codes reside in memory slots 03-20.
•
To add a user code to a specific memory slot (03 -20), refer "RegulatoR Programming Mode" to enter programming mode.
User codes must be 4 to 8 digits in length and must be different from all existing codes (including Slot 01 Supervisor & Slot 02 User
codes).
NOTE: There is a 10 second programming time limit between each step. If RegulatoR times out or an error is made, programming will
end and you will need to enter programming mode again.
1.
Place RegulatoR into programming mode (See "RegulatoR Programming Mode").
2.
Press "411" and then press ENTER.
3.
Type memory slot to be added followed by ENTER (for memory slots 03 - 09, you must type leading "0" – e.g. "07" for slot 7).
4.
Retype memory slot to be added followed by ENTER.
5.
Type the new user code and press ENTER.
6.
Retype the new user code and press ENTER.
7.
If successful, the yellow indicator light will illuminate.
Continue programming or press 9 and then ENTER to exit programming.
Delete User Without Specifying Memory Slot
The Supervisor Code memory location is called Slot 01 and the first User Code is called Slot 02.
•
The additional user codes reside in memory slots 03-20.
•
To delete a user code without specifying a memory slot (03 -20), refer "RegulatoR Programming Mode" to enter programming
mode.
NOTE: There is a 10 second programming time limit between each step. If RegulatoR times out or an error is made, programming will
end and you will need to enter programming mode again.
1.
Place RegulatoR into programming mode (See "RegulatoR Programming Mode").
2.
Press "400" and then press ENTER.
3.
Type the user code to be deleted and press ENTER.
4.
Retype the user code to be deleted and press ENTER.
5.
If successful, the yellow indicator light will illuminate.
Continue programming or press 9 and then ENTER to exit programming.
FLEXLINE ELECTRONIC PIN LOCK — INSTRUCTIONS FOR USE
5
www.metro.com
L01-655
REV 01/20
Publicité
