Panasonic Aquarea PAW-DHWM200A Notice D'utilisation page 53

PV detection
The connection of the PV module to the heat pump must be performed by a qualified expert. On the back side of the heat pump,
under the connection cord, there is a PV connection port. The PV port is shown in figure 16. Use a connection cord (minimum
inner cross-section 0,5 mm , H05VV-F 2G 0,5 mm
2
described in the chapter above
Figure 16: PV connection location
Connect the cord to the clamp, located under the control unit. The connection location is marked with PV.
Use ports 1 and 2.
Figure 17: PV connection port
and maximum external cross-section of 10 mm). The removal of the cover is
2
1
2
53