Broan best ISER222 Mode D'emploi page 4

CONNECT DECORATIVE FLUE
1. Secure the upper decorative flue section
to the upper support frame.
2. Temporarily hang the lower decorative flue
section from the support frame.
MOUNT HOOD TO SUPPORT
FRAME
1. Insert four (4) bolts through the top of the
hood - from the inside.
2. Use four (4) nuts to secure hood to support
frame as shown.
WIRING
Note: This range hood must be properly
grounded. The unit should be installed by a
qualified electrician in accordance with all
applicable national and local electrical
codes.
1. Remove the wiring box cover. Remove a
knockout from the wiring box.
2. Feed 6" of power cable through the knock-
out opening and secure cable to the wiring
box with an appropriate connector.
3. Make electrical connections. Connect white
to white, black to black and green to green.
4. Replace wiring box cover and screws. Make
sure that wires are not pinched between
cover and box.
UPPER
DECORATIVE
FLUE
SECTION
LOWER
DECORATIVE
FLUE
SECTION
- 4 -
NUT
BOLT
WIRING BOX
COVER