Télécharger Imprimer la page
LEGRAND Wiremond OFR Serie Instructions D'installation
LEGRAND Wiremond OFR Serie Instructions D'installation

LEGRAND Wiremond OFR Serie Instructions D'installation

Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

OFR Series
Overfloor Raceway Base & Cover
I N S T
L L
T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 009 724 – February 2011
PRODUCTS COVERED: OFRBC, OFRB, OFRC, OFR1, OFRWC, OFR9, OFR11
Base & Cover (OFRBC, OFRB, OFRC)
1. Drill 1/4" [6mm] diameter holes in both outer channels of
the raceway base for installation of mounting screws.
Holes should be drilled no further than 3" [76mm] from
each end of the raceway base and no more than 24"
[610mm] apart.
NOTE: Not recommended for use in high traffic areas.
Couplings (OFR1)
1. Slide one (1) coupling into each of the outer channels of
the base and secure the #8-32 screw.
2. Slide next section of base onto other end of coupling
and secure #8-32 screws.
Ground Clip (OFR9)
1. Lay ground clip into outer channel and rotate into grooves.
2. Tighten the #8-32 screws.
Legrand/Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
ll electrical products may present a possible shock or fire
hazard if improperly installed or used. Legrand/Wiremold electrical
products may bear the mark of a Nationally Recognized Testing
Laboratory (NRTL) and should be installed in conformance with current
local and/or the National Electrical Code.
IMPORT NT: Please read all instructions
before beginning.
2. Using #8 fasteners, install base of raceway directly on
top of existing floor covering. The screw type should be
appropriate for the type of floor, which the raceway is
being installed on.
3.
ttach cover to base by aligning countersunk holes in
cover with the threaded center channel in the base.
Use #8-32 Flat Head screws provided to secure.
1
2

Publicité

loading

Sommaire des Matières pour LEGRAND Wiremond OFR Serie

  • Page 1 Legrand/Wiremold electrical systems conform to and should be properly grounded in compliance with requirements of the current National Electrical Code or codes administered by local authorities. ll electrical products may present a possible shock or fire hazard if improperly installed or used. Legrand/Wiremold electrical...
  • Page 2 Wire Clip (OFRWC) Outer Channels Inner Channels 1. Place all wires into raceway. Insert serrated edge of wire 1. Place all wires into raceway. Insert serrated edge of wire clip under the inner slot of the base. clip against inner wall of the channel. 2.
  • Page 3 Les produits électriques Legrand/Wiremold peuvent porter la marque d'un laboratoire de vérification reconnu à l'échelle nationale (NRTL) et devraient être installés en respectant le Code national de l'électricité en vigueur ou les codes locaux.
  • Page 4 Pince à fil (OFRWC) Canaux externes Canaux internes 1. Posez tous les fils sur la piste. Insérez le bord serré de la 1. Posez tous les fils sur la piste. Insérez le bord serré de la pince à fil sous la fente externe de la base. pince à...
  • Page 5 Todos los productos eléctricos pueden presentar una posible descarga o riesgo de incendio si no son utilizados o instalados adecuadamente. Los productos Legrand/Wiremold pueden llevar la marca del Laboratorio de Pruebas Reconocido a Nivel Nacional (NRTL, por sus siglas en inglés) y deben ser instalados conforme el Código Eléctrico Nacional y/o local...
  • Page 6 Sujeta cables (OFRWC) Canales internos Canales exteriores 1. Coloque todos los cables en la canaleta para cables. 1. Coloque todos los cables en la canaleta para cables. Introduzca el borde serrado del sujeta cables en la ranura Introduzca el borde serrado del sujeta cables contra la interior de la base.
  • Page 8 60 Woodlawn Street • West Hartford, CT 06110 1-800-621-0049 • F X 860-232-2062 • Outside U.S.: 860-233-6251 Canada: 570 pplewood Crescent • Vaughan, Ontario L4K 4B4 1-800-723-5175 • F X 905-738-9721 1 009 724 0211 © Copyright 2011 Legrand/Wiremold ll Rights Reserved...

Ce manuel est également adapté pour:

Wiremond ofrbcWiremond ofrbWiremond ofrcWiremond ofr1Wiremond ofrwcWiremond ofr9 ... Afficher tout