Publicité
Les langues disponibles
Les langues disponibles
a
MI/1609 - 6
ed. ENG - 09/2016
installation and maintenace sheet
NB: These assembly instructions must be given to end users for correct maintenance and so that they know how to change the bulb. The appliance must not be tampered with
or transformed and it must be installed and used as supplied and in compliance with the National Rules on Installations. Any non-compliant installations will invalidate all forms
of guarantee. THE COMPANY CANNOT BE HELD RESPONSIBLE FOR DAMAGE CAUSED BY INCORRECT ASSEMBLY.
163
• max wind exposed surface 0,05m
• weight 4kg
• mounting height up to 15m
Ø 200
140
70
accessory
connection ACS/CR1
Quality control: In case of complaint please get in touch with our company or its sales organization. Please give the number of your order as well as the serial
number that recognizes the fixture.
Features - meaning of the symbols shown on the label:
suitable for exterior or interior free air operation
wall - ceiling - structure - pole mounting
Class I
Class II
2
SUPPLIED
CABLE
accessory
connection
ACS/CR1
n° 3 holes Ø 7mm
n° 2 holes Ø 7mm
totally dust-proof -
IP66
water-proof on ships' decks
Version
SIMPLE INSULATION: earth required
Version
DOUBLE INSULATION: no earth required
minimal distance between fitting and lighted object,
0,5
follow label directions
replace the damaged protective glass screens
getting rid of as urban waste forbidden
separate collection is mandatory when the product
is at the end of its life
glass features:
plane float - safety tempered - thickness 4mm
Cod.
T
(C°)
a min
D30T/LW
-20
D30T/HP-LW
-20
ATTENTION: Switch-off the power supply before
any installation and maintenance operations
INSTALLATION:
• The fixtures are complete with a piece of H07RN-F cable which is pre-connected
and sealed. For a rapid and safe connection with electric line use the connector
ACS/CR1 or an equivalent system, that guarantees at least the IP66 degree.
Connect following the indicated polarities.
• For outdoor locations it is mandatory to use (EN 60598-1) a trile core
(two core - Class II) flexible neoprene rubber cable type H07RN-F with a diameter
between 8 and 11mm, recommended section 3x1mm
PVC insulated cables or with outer PVC cover or anyhow cable different
from the one here prescribed are not allowed. Tighten carefully the cable
gland being sure that the sealing gasket does not come out from its seat.
MAINTENANCE:
• it is essential to do a frequent cleaning of the glass and of the outer surface
of the fixture to avoid build up of mud and dirtiness resulting in dangerous
overheating due to uncorrect light and heath dissipation.
Clean carefully the glass screen removing limestone deposits by means
of a scraper.
LED VERSION:
The light source contained in this device must only be replaced by the manufacturer
or its assistance service or by an equally qualified person.
1
product in compliance with the requirements
of the European Community Directories
T
(C°)
a max
* MAXIMUM WORKING TEMPERATURE.
60*
THE FITTING MUST BE INSTALLED IN
40*
AN ENVIROMENT WITH THESE
2
(2x1mm
D30T - boxerT
VALUE.
2
- Class II).
Publicité
