Rothenberger ROMAX Compact Instructions D'utilisation page 25

The lithium-ion battery can be charged at any charging level and charging can be interrupted at
any time without damaging the battery (no memory effect).
 Insert plug of the battery charger into a wall socket. LED (4) red lights up
 Connect the battery (1) to the battery charger (2): LED (3) green lights up. Battery is
charged . LED (3) green flashes: Battery is fully charged (For charging time, see Technical
Data).
 Remove the battery.
 Disconnect plug from the wall socket.
Storage:
The place of storage must be inaccessible to children.
 Remove the battery.
 Disconnect plug from the wall socket.
 Store battery charger in a dry, frost-proof location.
Store the battery only in a charged state! Fully recharge the battery after 12 months of stor-
age, at the latest!
Troubleshooting:
Before evaluating faults, disconnect the plug!
- LED (3) red flashes: Battery temperature outside the permissible charging temperature (5°C to
45°C / 41°F-113°F).
The Charging will begin automatically once the battery reaches the correct charging tempera-
ture.
In the event of other faults, please contact ROTHENBERGER Service. Repairs should only be
carried out by ROTHENBERGER service centres or dealers authorised by ROTHENBERGER.
LED's:
LED left (4)
lights up red
flashes red
4 Care and Maintenance
ROMAX Compact:
Remove the battery prior to carrying out any work on the machine.
Check that the press jaws are fully functional. Damaged press jaws must not be used and must
be sent to an authorised ROTHENBERGER repair shop.
Check that the press jaw and drive rolls move freely.
Check the bolt for signs of damage at regular intervals. Have damaged bolts replaced by an au-
thorised ROTHENBERGER repair shop.
Clean and grease the drive rolls, the bolt and press jaws when you have finished work.
Use only high quality pressing or ball bearing grease.
The pressing contour must be kept free of grease.
All other servicing, maintenance and repair work must be carried out by an authorised
ROTHENBERGER repair shop.
If the seal is damaged the warranty will be null and void.
After 10.000 pressing cycles or 1 year have the machine serviced by an authorised ROTHEN-
BERGER workshop.
When dispatching the machine ensure that it is packed in its carrying case completely with bat-
tery and charger in the carry case only.
Electro-hydraulic machine does not exceed 3 hours in a -5° C / 23°F storage.
Charger ready for operation lights up green
Charger is defective
LED right (3)
flashes green
lights up red
flashes red
ENGLISH
Charging started
Battery is fully charged
Battery is defective
Battery is too hot or too cold
19