Axis Q1775 Guide D'installation page 12

AXIS Q1775 Network Camera
Power LED
Green
Amber
Status LED Behavior and Buzzer Signal for Levelling Assistant
For information on using the control button to start levelling of the camera, see page 13.
Color
Fixed green
Flashing green
Flashing orange
Flashing red
Connectors and Buttons
For specifications and operating conditions, see page 14.
Network Connector
NO NO TICE NO TICE TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
electrical environments shall be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer's instructions. For information
about regulatory requirements, see Electromagnetic Compatibility (EMC) on page 2 .
I/O Connector
Use with external devices in combination with, for example, tampering alarms, motion detection,
event triggering, time lapse recording and alarm notifications. In addition to the 0 V DC reference
point and power (DC output), the I/O connector provides the interface to:
• Digital output – For connecting external devices such as relays and LEDs. Connected
devices can be activated by the VAPIX® Application Programming Interface, output
buttons on the Live View page or by an Action Rule. The output will show as active
(shown under System Options > Ports & Devices) if the alarm device is activated.
• Digital input – An alarm input for connecting devices that can toggle between an open
and closed circuit, for example: PIRs, door/window contacts, glass break detectors,
www.a1securitycameras.com email: sales@a1securitycameras.com
Indication
Normal operation.
Flashes green/amber during firmware upgrade.
Buzzer
Continuous beep
Fast interval
Medium interval
Slow interval
Available from A1 Security Cameras
Camera position
Level
Almost level
Not level
Far from level
12