Axis Q1775 Guide D'installation page 17

Connection Diagrams
I/O Connector
1
0 V DC (-)
2
DC output 12 V, max 50 mA
A
I/O configured as input
B
I/O configured as output
Install the Hardware
Connect the Cables
Attach the metal stand to the camera and use appropriate screws for the wall/ceiling material.
Note that the camera is designed to be installed with the logotype facing down.
1. Optionally connect external input/output devices, e.g. alarm devices. See Connectors on
page 15 for information on the connector pins.
2. Optionally connect an active speaker and/or external microphone.
3. Connect the camera to the network using a shielded network cable.
4. Connect power, using one of the methods listed below:
- PoE (Power over Ethernet, Class 3). If available, this is automatically detected
when the network cable is connected.
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
AXIS Q1775 Network Camera
1
2
A
B
17