Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Maintenance
1. If your tool is not using an in-line
automatic oiler, place 2 or 6 drops of
pneumatic tool oil into the air inlet
before each work day or after 2 hours
of continuous use, depending on the
characteristic of workpiece or type of
fasteners.
2. Check and change all worn or damaged
o-rings, seals etc. Tighten all the
screws and caps to prevent personal
injury. Keep magazine and nose of tool
clean and free of any dirt, lint or
abrasive particles.
No Description
1 Bolt
2 Deflector spring
3 Air deflector
4 Bolt M5 x 20
5 Spring
6 Cylinder cover
7 Sealing washer
8 Compressed spring
9 O-ring
10 O-ring
No Description
11 Head valve piston
12 O-ring
13 Sealing washer
14 O-ring
15 Collar
16 O-ring
17 O-ring
18 Cylinder
19 Seal wash
20 Main piston
21 O-ring
No Description
22 Bumper
23 Gun body
24 Rubber washer
25 Rectangle seal
26 Inner valve seat
27 Trigger valve stem
28 O-ring
29 Trigger valve guide
30 O-ring
31 Compressed spring
32 Step pin
Publicité
Table des Matières
