Mounting And Operation; Maintenance And Cleaning; Service Indicator - Würth MH 11-XE Traduction Des Instructions De Service D'origine

OBJ_BUCH-2206-001.book Page 13 Tuesday, May 20, 2014 2:01 PM
The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Action
Insert the SDS-max application tool
Removing the SDS-max application
tool
Changing the chisel position
(Vario-Lock)
Adjusting the auxiliary handle
Switching On and Off
Setting the Impact Rate
Observing the service indicator

Maintenance and Cleaning

 For safe and proper working, always keep the
machine and ventilation slots clean.
When replacing the power tool's cable is required, have this
carried out by a Würth master-Service or by an authorised
customer services agent for Würth power tools, in order to
avoid hazardous situations.
In all correspondence and spare parts orders, please always
include the article number given on the type plate of the
machine.
The current spare parts list for this power tool can be viewed
in the Internet under
"http://www.wuerth.com/partsmanager"
or be requested from your next Würth branch office.

Mounting and Operation

Figure
1
2
3
4
5
6
7

Service Indicator

(see Fig. 7, page 162)
When the carbon brushes are worn out, the machine switches
itself off. This is indicated approx. 8 hours beforehand by the
lighting or blinking of the service indicator . The machine must
then be sent to an after-sales service agent.
Service indicator flashes in regular intervals, the machine is
defective. In this case, do not continue to use the machine and
send it immediately to an after-sales service agent.
Please observe Page
160
160
161
161
162
162
162
13