Emos Select ESW5003 Manuel D'instructions page 8

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 74
Step 3
Insert the other side of the pole to the square hole
of the plastic stand.
Note:
Ensure the pole and stand's indicator align.
Step 4
Place the nut in the hexagon hole of the stand,
then insert the screw in other side and then tighten
it by the screw driver.
Install the wireless 5-IN-1 sensor
in an open location with no
obstructions above and around the
sensor for accurate rain and wind
measurement. Install the sensor
with the smaller end facing the
North to properly orient the wind
direction vane.
Secure the mounting stand and
clamps (included) to a post or
pole, and allow minimum 1.5m off
the ground.
Make sure the sensor is not tilted.
Check the spirit level on top of the
sensor for this.
A. Mounting on pole (Pole Diameter 1"~1.3"
(25~33mm)
Add rubber
pads before
mount on
the pole
B. Mounting on the railing
8
Point to
NORTH
1.5 meter off
the ground

Hide quick links:

Publicité

Table des Matières
loading

Produits Connexes pour Emos Select ESW5003

Table des Matières