Hi/Lo Alert; Wireless Signal Reception - Emos Select ESW5003 Manuel D'instructions

HI/LO ALERT

HI/LO alert are used to alert you of certain weather conditions. Once activated, the alarm will turn on when a
certain criterion is met. The following are areas and type of alert provided:
Indoor temperature
Outdoor temperature
Outdoor humidity
TO SET THE HI/LO ALERT
1. Press the [ ALERT ] key until the desired area is selected.
] key / [
2. Use[
3. Press the [ ALERT ] key to confirm and continue to next setting.
TO ENABLE / DISABLE THE HI / LO ALERT
1. Press the [ ALERT ] key until the desired area is selected.
2. Press the [ ALARM ] key to turn the alert on or off.
3. Press the [ ALERT ] key to continue to next setting.
Note:
- The unit will automatically exit setting mode in 5 seconds if no key is pressed.
- When ALERT alarm is on, the area and type of alarm that triggered the alarm will be flashing and the alarm
will sound for 2 minutes.
- To silence the Alert alarm beeping, press the [ ALARM / SNOOZE ] / [ ALARM ] key, or let the beeping
alarm automatically turn off after 2 minutes.

WIRELESS SIGNAL RECEPTION

No sensor
The 5-IN-1 sensor is capable of transmitting data wirelessly over an approximate operating of 150m range (line
of sight). Occasionally, due to intermittent physical obstructions or other environmental interference, the signal
may be weaken or lost. In case that the sensor signal is lost completely, you will need to relocate the Display
main unit or the wireless 5-IN-1 sensor.
Area
Indoor humidity
Rainfall
Wind speed
] key to adjust the setting.
Signal searching
Type of Alert available
HI and LO alert
HI and LO alert
HI and LO alert
HI and LO alert
HI alert
(Daily rainfall since midnight)
Strong signal Weak signal
15
HI alert
Signal lost