Cleaning The Mixer - Hamilton Beach Commercial Mix'n Chill HMD200 Manuel D'utilisation

Cleaning the Mixer

Cleaning and Sanitizing the Container, Spindle, and Agitator
wWARNING
Electrical Shock Hazard
Disconnect power before removing or
cleaning the splash pan, spindle shaft,
and agitator.
Replace all parts before operating.
Failure to do so can result in death
or electrical shock.
Cleaning
1. Place a drop of detergent and 1 cup (250 ml) of water
into the mixing container.
2. Position the container under the mixing spindle and
mix on low speed for 5 seconds. Empty the mixing
container.
3. Place 1 cup (250 ml) of clean water into the container
and repeat mix for 5 seconds to rinse.
NOTE: Inspect agitators daily. Replace agitators every
90 days.
Sanitizing
For best results, use the Hamilton Beach Universal
Container (#110E).
1. Fill the container with sanitizing solution (1 tablespoon
[15 ml] of household bleach per 1 gallon [3.8 L] of
water at 50°–70°F [10°–21°C]) to 3/4 full. Position the
container under the mixing spindle and run on low
speed for 1 minute.
2. Remove container. Empty sanitizing solution and rinse
container.
3. To dry, run the mixer on low speed for 30 seconds
with empty container in place. DO NOT RINSE after
sanitizing is completed.
NOTE: If preferred, the container and agitator may be
cleaned in a commercial dishwasher.
7