Velleman VISP1 Notice D'emploi page 3

VISP1 – INDOOR PAN-TILT SCANNER - 24VAC
1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialized
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If the
device was damaged in transit, don't install or use it and contact your dealer.
2. Installation and Maintenance
Install the unit on a wall bracket by means of the included stainless steel ¼"x20 screws. Secure the VISP1 to the wall
bracket by fastening the screws from the bottom of the wall bracket into the unit. The VISP1 requires no lubrication or
maintenance for the life of the unit.
3. Wiring
Compose the interconnecting cable in accordance with the figure below for proper operation.
1. AUTO PAN (red)
2. COMMON (black)
3. TILT DOWN (yellow)
4. TILT UP (blue)
5. PAN RIGHT (green)
6. PAN LEFT (white)
Inverted Mounting: When the unit is mounted in the inverted position, the left-right directions are reversed for manual
operation. This must be corrected when wiring the cable between the control unit and the VISP1. Simply reverse the
leads going to terminals 5 and 6.
4. Adjusting Limit Stops
1. PAN RIGHT limit stop
2. Limit switch
3. PAN LEFT limit stop
4. Camera mounting plate
5. Connection to camera output
6. Connection to control unit
7. Video output
When the cable is installed and unit has been mounted, plug the control
unit into 24VAC source. Make sure the auto switch is in the OFF position.
Adjust the pan limit stops by taking them off and putting them where you
want them to be.
VISP1_v2
- 3 - VELLEMAN