Fitting Instructions - Burg Wächter RS 110 C SB Instructions De Montage Et Mode D'emploi

Lock
The combination must be scrambled by
rotating the 4 dials. The slide bolt can be
latched both while open and closed.

Fitting instructions

Note: Regular screws can be used to tem-
porally fix the locking bolt before finally
fixing using the security screws supplied.
It is important to drill a small pilot hole for
the screws as they cannot be unscrewed
once used.
1 Hold the slide bolt in the required
position and check the slide bolt and the
gate / door will function correctly. Once
positioned correctly, mark the location of
the 4 screw holes.
2 The slide bolt should be mounted using
all the 4 corner fixing holes on the back
plate. Drill a small pilot hole for the
screws. Screws should be tight without
distorting the back plate.
Depending on the material of the installation
place it may make sense to drill small gui-
ding holes to facilitate fitting. Drills should
be chosen according to material and screw
diameter. It may be advantageous to use
dowels.
8 | English RS 110 C SB