Witter KA39U Notice De Montage

MATERIALS
A 1 Cross Bar
B 4 M12 x 120 x 1.75mm Bolts, Serrated Nuts and 8 Flat Washers (30mm O.D.)
C 6 M12 x 35mm x 1.75mm Bolts and Serrated Nuts
D 1 Right Side arm (6 slotted holes)
E 1 Left Side arm (4 slotted holes)
F 1 Left Hand side plate (2 small dowel holes)
G 1 Right Hand side plate
H 4 M10 x 35 x 1.25mm Fine Pitch Bolts, 40 O.D Flat Washers and Lock Washers
J 3 M12 x 40mm x 1.75mm Bolts, Serrated Nuts and 6 Flat Washers (30mm O.D.)
Electrical Plate (ZEP6) – packed with detachable neck(ZQ)
EP 1
Detachable unit – 2070 series
ZQ 1
FITTING
1. Remove spare wheel.
2. Loosely attach side arms (D) & (E) and Side Plates (F) and (G) (at rearmost holes, Note: foreword most holes not used on
this application) to chassis frame using fixings (B) and (H).
3. Insert Cross Bar (A) into position and loosely attach to Side Plates (F) using fixings (C) and to side arms (D) & (E) using
Bolts (J).
4. Fully tighten all bolts ensuring cross bar is flush with lower edge of bumper.
5. Fit ZQ unit and electrical plate EP referring to separate fitting instruction.
6. Re-fit spare wheel. Note: Due to the reduced space available for the spare wheel due to the towbar crossbar position it
may be necessary to feed the wheel around the crossbar as it is raised into position.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M8 - 27Nm, M10 - 53 Nm, M12 - 95 Nm, M14 - 150 Nm, M16 - 214 Nm
WITTER TOWBARS
Deeside Ind. Park, Deeside, CH5 2NY
Fitting
Instructions
For Kia Sorento 2013 and Hyundai Santa Fe
www.witter-towbars.co.uk
Detachable TOWBAR
2012 -
KA39U
Issue 1