Witter KA33U Mode D'emploi

Fitting
Instructions
MATERIALS
A 1 Main Crossbar.
B 1 Bent Spreader Plate.
D 6 M10 x 35 x 1.25 Fine pitched bolts Lock washers and Flat Washers (30O/D)
ZE 1 Electrical Plate.
ZN 1 Neck Option.
FITTING
No need to remove the bumper.
1.
Remove the towing eye on the right hand side.(Hand to customer)
2.
Loosly attach part "A" to the chassis, using 4 off fixings "D" . 2 off each end.
3.
On the right hand side of the vehicle hold the main crossbar "A" up against the chassis rail and insert the bent spreader
4.
plate "B" onto the bolts and over the top of the end profile via the slots, using the final two fixings "D" to bolt into the
vertical face of the chassis.
Attach chosen neck option.
5.
6. Fully tighten all fixings to the correct torques
Recommended torque settings: Grade 8.8 bolts: M8 - 24Nm, M10 - 52 Nm, M12 - 80 Nm, M14 - 130 Nm, M16 - 200
Nm Grade 10.9: M12 – 120Nm, M10 – 70Nm M8- 35Nm
W0001KA33U-FIT$011205230000BÄ
W0001KA33U-FIT$011205230000
TOWBAR
For Kia Picanto 2011 -
KA33U