Before Installation; Installation Procedure - Toto CST243 Manuel D'installation

Masquer les pouces Voir aussi pour CST243:

Manuel d'installation (32 pages)

Table des Matières

Les langues disponibles

Read these instructions thoroughly before beginning work.

Please leave instructions for customers. These instruction contain maintenance

and warranty information.

If necessary, remove the existing toilet.

IMPORTANT!

Due to the powerful performance of our Cyclone, G-Max, E-Max and Power Gravity

ﬂushing systems, they are not speciﬁed for back-to-back installations. The only

means of installing these toilets in a back-to-back situation is when the toilet drain

connections incorporate a WYE ﬁtting. Please contact your builder or contractor prior

to this installation.

For your new TOTO toilet to ﬁt correctly, the rough-in, the distance between the

ﬁnished wall to the center of the

closet ﬂange, must be at least

12 inches for most models.

NOTE:

Models

rough-in have model numbers

ending with ".10", for example

C744EF.10.

1) Clean any debris out of the closet ﬂange

and then install new mounting bolts

(not supplied) into the slots of the closet

ﬂange (see Illustration 1). The head of the

bolt should be inserted into the slot with

its threads facing upward.

2) Carefully turn the toilet upside down

onto some padding. Firmly press a new

bowl wax ring (not supplied) onto the

circular recess around the toilet bowl's

horn (see Illustration 2). Turn the toilet

upright and gently lower into position

over the closet ﬂange. With toilet

properly aligned, press ﬁrmly on both

sides of toilet rim to set the bowl wax

ring (see Illustration 3).

CAUTION: Do not move the bowl after

the bowl wax ring is set. Thread the nuts

and tighten evenly until bowl is snug to

closet ﬂange. Install the bolt caps (see

Illustration 3).

CAUTION: Do not over-tighten the nuts

as damage to the china bowl may result.