Empire Comfort Systems Bonlevard DVP60LPZ-1 Instructions D'installation

INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE.
CARTON CONTENTS:
• Liner Panel
• Screw Package
• Side Retainer Brackets
(Qty. 2)
INSTALLATION
Sharp edges! To avoid injury, wear safety gloves to
install liner.
1. Refer to the fireplace installation manual for removal
of the Barrier and Glass Door assemblies prior to
installation of the liner kit.
2. The hearth and burner cover must be clear of
decorative media.
3. Carefully unpack the liner, verify that all components
are included, and inspect for hidden damage, prior to
installation.
4. Remove the front Light Cover (hearth ledge) by lifting it
up and out, then set it aside.
5. Use a 5/16" Nut Driver to install the two Side Retainer
Brackets at the front left and right side openings of
the firebox with two 5/16 X 1/2" screws each. These
brackets must be installed so the angle break is facing
rearward. See Figures 1 and 2.
35737-2-0220
INSTALLATION INSTRUCTIONS
DVP60LPZ-1 RIDGEBACK LINER KIT
FOR USE ON: DVLL60BP SERIES FIREPLACES ONLY
TOOLS NEEDED:
• Gloves
• Eye Protection
• 5/16" Hex Driver
CAUTION
Figure 1
Empire Comfort Systems Inc. • Belleville, IL
RIDGEBACK LINER KIT
When installing the liner, use extreme care to protect
the pilot assembly and igniter probes! See Figure 3.
Figure 2
CAUTION
CAUTION:
PILOT/IGNITOR PROBES
Figure 3
Page 1