Color Settings - Ditel DN109/NB Manuel Technique

TECHNICAL MANUAL
LARGE DISPLAYS DN109/NB - DN119/NB - DN189/NB
CHAPTER 22
Communication Settings
See Communication Settings

COLOR Settings

In the color settings screen, the parameters related to the color shown by the display are
configured. Note: Only applies in units with color option.
R0 and R1 are activation bits that depend on the configuration of parameters 6 and 10,
explained below:
23. Selects whether the display color is fixed (Red, Orange, Yellow or Green) or dynamic.
Depending on the selection between fixed or dynamic, a greater or lesser number of
configuration parameters will be displayed.
24. Set the desired color for the case R1 = OFF and R0 = OFF. In 3, 4 and 5 the color is
established for each case of activation of bits R0 and R1.
25. Select the activation condition of R0.
G. VAL>TRIG: It activates bit R0 when the value sent to the display is greater than the
value established in parameter 7.
H. VAL≤TRIG: It activates bit R0 when the value sent to the display is less than or equal
to the value established in parameter 7.
I. OFF: The R0 bit will always be inactive.
INITIALIZATION
at chapter 22.
Fig. 97: Web server color settings window.
22-10