Cutting Height Adjustment; Cutting String Replacement - Echo WT-1610T Manuel De L'opérateur

BEFORE INSPECTING OR SERVICING ANY PART OF THIS MACHINE, SHUT OFF POWER SOURCE, DISCONNECT
SPARK PLUG WIRE FROM SPARK PLUG AND MAKE SURE ALL MOVING PARTS HAVE COME TO A COMPLETE STOP.

5.3 CUTTING HEIGHT ADJUSTMENT

height:
1. Remove front cover.
2.
trimmer shaft with the opening.
3.
to hold the trimmer shaft. Rotate until the wrench is
braced against the trimmer body.
4. To remove, turn the mow ball counterclockwise (when
the trimmer plate can also assist with loosening the
mowball.
5. Turn trimmer disk over and replace on trimmer
spindle.

5.4 CUTTING STRING REPLACEMENT

Cutting string is available in two thicknesses, 155 mil
(standard) and 175 mil (heavy duty). The type of string
selected is dependent on the conditions and material
being cut.
Cutting string can be wrapped in a variety of ways. Refer
to Figures 5.2, 5.3, and 5.4 for examples. The wrapping
method and cutting string thickness chosen is ultimately
based on what is determined the best for the operator.
follow the steps below.
1. Feed the cutting string through the second hole on
(20.3 cm) for the cutting surface. Total recommended
2. Continue by weaving the cutting string through the
step 1. Pull the cutting string tight.
3.
hole on the opposite end of the trimmer head.
4. Feed through the remaining second hole and pull the
cutting string tight. The cutting strings in the middle
two holes should be the same length. If the length
5. Optional method. Tie knot in middle of string. Insert
loose ends through holes in trimmer plate.
WARNING
6. Reinstall the mow ball and turn clockwise (when
viewed from below) to tighten.
Trimmer
Figure 5.1, Cutting Height Adjustment
Figure 5.2 Wrapping the Cutting String
Figure 5.3 Optional Wrapping Method
Figure 5.4 Optional Wrapping Method
WHEELED TRIMMER
SERVICE & MAINTENANCE
Disk
Mow Ball
Front
Cover
9