Orbegozo CP 97132 Manuel D'instructions page 12

CP 97132
3. Slide the rod down through the pin and insert the wires through the tube.
4. Mount the ceiling support using 2 screws and washers.
5. Make sure that the hook on the base fits correctly with the groove of the dial.
6. Insert the receiver of the remote control as shown in the image.
7. Connect the power supply cables to the ceiling support strip, respecting its corresponding polarity:
phase-phase, neutral-neutral, earth-ground.
8. Attach the bowl to the ceiling support, aligning the side holes and secure it by tightening the screws
9. Insert the connectors securely. Place the LED board in the light kit and it will stick magnetically.
10. Install the ceiling light on the lamp by turning it clockwise.
OPERATING THE FAN
Select the fan speed by pressing the speed control button on the remote control transmitter :

HI: High Speed
Program the fan for 1, 2, 4 or 8 hours by pressing the corresponding button and the fan will stop

working after the selected time has elapsed.
Pressing the 'ON/OFF' light button on the remote control transmitter can control the turning on or

off of the light.
MAINTENANCE
TO CHANGE THE LIGHT PLATE
1. Switch the appliance off (it is advisable to also switch off the circuit-breaker or breaker).
2. Remove the plug and remove the LED board.
3. Take a new LED board. Insert the connectors securely. Place the LED plate in the light kit.
4. Reset the power supply and turn on the lamp.
CLEANING
Clean with a soft, dry cloth. Never use scouring pads not abrasive or chemical cleaners. Do not allow
condensation to come in contact with the electrical components.
MED : Medium Speed LOW : Low Speed OFF : Off
12