Publicité

Les langues disponibles

Les langues disponibles

Liens rapides

393691 LP Gas and 394588 Natural
Gas Conversion Kits
FOR VR8200/VR8300/SV9500/SV9600 FAMILY OF COMBINATION
GAS CONTROLS
APPLICATION
The 393691 LP Conversion Kit changes
VR8200/VR8300/SV9500/SV9600 family combination
gas controls from regulated natural gas to regulated LP
gas. The 394588 Natural Gas Conversion Kit changes
VR8200/VR8300/SV9500/SV9600 family combination
gas controls from regulated LP gas to regulated natural
gas. Kits include a new cap screw, pressure regulator
adjustment screw, spring and conversion label.
To use this kit, assure gas control is equipped with a
standard or slow opening pressure regulator.
NOTE:
Step regulator valves cannot be converted.
INSTALLATION
When Installing this Product...
1. Read these instructions carefully. Failure to follow
instructions can damage product or cause a
hazardous condition.
2. Check ratings given in instructions and on product
to make sure product is suitable for your
application.
3. The installer must be a trained, experienced
service technician.
4. After installation is complete, use these instruc-
tions to check out product operation.
INSTALLATION INSTRUCTIONS
WARNING
Fire or Explosion Hazard.
Can cause severe injury, death or property
damage.
Follow these warnings exactly:
1. Disconnect power supply before wiring to
prevent electrical shock or equipment
damage.
2. To avoid dangerous accumulation of fuel gas,
turn off gas supply at appliance service valve
before starting installation and perform Gas
Leak Test after completion of installation.
3. Use only your hand to turn gas control knob.
Never use any tools. If gas control knob will
not operate by hand, then a qualified
technician should replace the gas control.
Force or attempted repair may result in fire or
explosion.
4. Change main and pilot burner orifices to meet
appliance manufacturer specifications.
To convert from one gas to another:
1. Turn off gas supply at the appliance service valve.
2. Remove regulator cap screw and pressure
regulator adjusting screw. Refer to Fig. 1.
3. Remove the existing spring.
4. Insert the replacement spring. Refer to Fig. 2.
PRESSURE REGULATOR
ADJUSTMENT
(UNDER CAP SCREW)
INLET
PRESSURE TAP
INLET
1
THERMOCOUPLE
CONNECTION
1
RED
RESET
BUTTON
1
THERMOCOUPLE CONNECTION AND RED RESET BUTTON
ON STANDING PILOT MODELS ONLY.
Fig. 1. Top view of VR8200 combination gas control.
CONVENIENCE
WIRING
TERMINALS (2)
TERMINALS (2)
(OPTIONAL)
OUTLET
PRESSURE
TAP
OUTLET
PILOT OUTLET
PILOT ADJUSTMENT
GAS
(UNDER CAP SCREW)
CONTROL
KNOB
69-0244EF-03
M8084

Publicité

Table des Matières
loading

Sommaire des Matières pour resideo 393691

  • Page 1 393691 LP Gas and 394588 Natural Gas Conversion Kits FOR VR8200/VR8300/SV9500/SV9600 FAMILY OF COMBINATION GAS CONTROLS INSTALLATION INSTRUCTIONS APPLICATION WARNING Fire or Explosion Hazard. The 393691 LP Conversion Kit changes Can cause severe injury, death or property VR8200/VR8300/SV9500/SV9600 family combination damage.
  • Page 2 2. Turn gas control knob counterclockwise preliminary pressure setting is approximately 10.0 PILOT. Push down and hold the knob while lighting in. wc (2.5 kPa) for LP gas regulator (393691) and the pilot flame. 3.5 in. wc (0.9 kPa) for natural gas regulator 3.
  • Page 3 393691 LP GAS AND 394588 NATURAL GAS CONVERSION KITS 6. If necessary, adjust pressure regulator to match appliance rating. (On step-opening regulators, PROPER FLAME match the full rate outlet pressure.) ADJUSTMENT a. Remove pressure regulator adjustment cap 3/8 TO 1/2 IN.
  • Page 4 Resideo Technologies, Inc. 1985 Douglas Drive North, Golden Valley, MN 55422 1-800-468-1502 www.resideo.com 69-0244EF—03 M.S. Rev. 03-20 | Printed in United States © 2020 Resideo Technologies, Inc. All rights reserved. This product is manufactured by Resideo Technologies, Inc. and its affiliates.
  • Page 5 COMBINAISONS VR8200/VR8300/SV9500/SV9600 NOTICE D'INSTALLATION APPLICATION AVERTISSEMENT La trousse de conversion 393691 pour le gaz de pétrole Risque d’incendie ou d’explosion. liquéfié fait passer les appareils de contrôle du gaz de la Peut causer des blessures graves, le décès ou famille de combinaisons des dommages matériels.
  • Page 6: Démarrage

    TROUSSES DE CONVERSION 393691 POUR LE GAZ DE PÉTROLE LIQUÉFIÉ ET 394588 POUR LE GAZ NATUREL Effectuer un test de fuite de gaz CODE COULEUR POUR NATUREL AVERTISSEMENT NOIR ARGENT D'OBTURATION JOINT TORIQUE NOIR NOIR Risque d’incendie ou d’explosion. VIS DE Peut causer des blessures graves, le décès ou...
  • Page 7: Vérifier Et Régler L'entrée De Gaz Et L'allumage Du Brûleur

    TROUSSES DE CONVERSION 393691 POUR LE GAZ DE PÉTROLE LIQUÉFIÉ ET 394588 POUR LE GAZ NATUREL Ajuster la flamme de la veilleuse Vérification de la pression du gaz à l’aide d’un manomètre (indicateur La flamme de la veilleuse devrait envelopper 10 à 13 mm (3/8 à...
  • Page 8 TROUSSES DE CONVERSION 393691 POUR LE GAZ DE PÉTROLE LIQUÉFIÉ ET 394588 POUR LE GAZ NATUREL a. Pour les cadrans de compteur de gaz à un pi Temps (s) Débit (pi Débit (m par rotation, utilisez directement le Tableau 1.

Ce manuel est également adapté pour:

394588

Table des Matières