Hansgrohe AXOR Starck 10930 1 Serie Instructions D'installation page 14

English
Steel / Citterio M / Uno
Install the snap connector.
Install the screw, but tighten it by hand only three
turns.
Push the handle over the snap connector.
Tighten the screw.
Install the screw cover.
Citterio / Massaud
Install the snap connector.
Tighten the screw.
Install the handle.
Tighten the screw using a 2 mm Allen wrench.
Massaud only: Install the icons on the handle.
2mm
Massaud: Seal the wall at the grout lines using
Massaud
waterproof sealant.
14